Besteht ein Aluminiumstabquerschnitt aus schlanken Elementen, besteht die Möglichkeit des Versagens aufgrund von lokalem Beulen der Flansche oder Stege, bevor der Stab die volle Steifigkeit erreichen kann. Im Zusatzmodul RF-/ALUMINIUM ADM gibt es jetzt drei Optionen, um die nominale Biegefestigkeit für den Grenzzustand des lokalen Beulens zu bestimmen, Mnlb, aus Abschnitt F.3 des 2015 Aluminum Design Manual. Alle drei Methoden beinhalten die Abschnitte F.3.1 Methode des gewichteten Mittelwerts, F.3.2 Direkte Festigkeitsmethode und F.3.3 Methode der Begrenzungselemente.
In the AISC 360 – 14th Ed. C2.2, the direct analysis method requires initial imperfections to be taken into consideration. The important imperfection of recognition is column out-of-plumbness. According to C2.2a, the direct modeling of imperfections is one method to account for the effect of initial imperfections. However, in many situations, the expected displacements may not be known or easily predicted.
Requirements for the design of structural stability are given in the AISC 360 – 14th Ed. Chapter C. In particular, the direct analysis method provisions, previously located in Appendix 7 of the AISC 360 – 13th Ed., are described in detail. This method is considered an alternative to the effective length method, which in turn eliminates the need for effective length (K) factors other than 1.0.